Skip to main content

Anritsu FAQs

From the frequencies 250 - 320 MHz my MS2026A does not look correct. It has a saw tooth look between these frequencies. This was intermittent as a power off/on would fix it for a short time. Then I noticed the IF Cal is OFF warning.
Factory Calibration is OFF. Insure that the battery level is adequate for operation or that the temperature is within acceptable limits. Reset to factory defaults with either Factory Defaults, ESC+ON, or MASTER RESET, System + ON. Caution: Use of MASTER RESET, System + ON, will erase all user saved setups and measurement traces and return the unit to a factory default condition. If the error persists, then contact your Anritsu Service Center.
Brochures Datasheets and Catalogs

Related Links

FAQ Feedback

FAQ Feedback
Does this FAQ answer your question?*
How do you rate the quality of this content?*
If you would like to be contacted by an Anritsu representative, please let us know the best way to reach you.