Skip to main content
MENU

다운로드 센터

제품 모델 번호별 검색

By Document Type

BERTWave Series Remote Control Operation Manual

BERTWave Series Remote Control Operation Manual

조작 메뉴얼 pdf 3.2 MB Version: Ninth Edition 2018/09/03

'Linked by Light' Evaluating Gbit/s Ultra-Fast Serial Signals

The all-in-one BERTWave MP2100B also supports Total Jitter component analysis required for developing and manufacturing AOC. The AOC interface can be evaluated during simultaneous sending and receiving to simplify evaluation of AOC characteristics and transmission-path quality.

리플렛 pdf 518.9 KB 2018/07/23

'Linked by Light' Evaluating Hi-Definition Video Transmissions

With a built-in BERT and sampling oscilloscope, the BERTWave MP2100B is the ideal, low-cost measurement solution for evaluating both the characteristics of optical transceivers and AOC, as well as transmission-path quality.

리플렛 pdf 542.7 KB 2018/07/23

BERTWave Series (MP2110A and MP2100B)

The BERTWave series is designed especially for mass-production of optical modules and features an All-in-one BERT (for bit error rate measurement) plus sampling oscilloscope (for Eye pattern analysis) to help increase optical module production efficiency and cut costs.

팜플렛 pdf 2.0 MB 2018/05/07

Selecting Tools at Measurement of High-Speed Digital Signals

The recent rapid increases in data volumes at network equipment, servers, and storage due to increasing use of smartphones, cloud computing, FTTx rollout, video streaming, etc., seem likely to increase even further in future. To cope with demand, many appliances and facilities are using digital signals exceeding the Gbit/s band. Dealing with these high-speed signals requires paying attention not only to the digital aspects but also to analog-type behavior, and care is required in choosing tools for monitoring these signals. This document discusses the key points when handling digital signals exceeding 10 Gbit/s from the perspective of measurement tools.

테크니컬 노트 pdf 1.0 MB 2017/07/14

Measurement Environment Solutions for Eliminating ESD/EOS Failures

Electronic components of electronic devices and measurement devices break down when subjected to high voltages caused by electrostatic discharge (ESD) or electrical over-stress (EOS).Signals sent to I/O connectors of electronic, measurement and other devices must be within the rated voltage or the devices may fail. This document should be used to help build an environment that avoids ESD or EOS.

application note pdf 1.4 MB 2017/03/30

Ideal Remote Sequence

This note introduces standard remote sequences making use of the BERTWave functions and speed to measure optical modules and devices. The remote sequences described in this note can be used to configure a simple test system for manufacturing optical modules and devices by selecting the best commands from remote commands built into the BERTWave.

application note pdf 602.4 KB 2017/02/22

MP2100B BERTWave Operation Manual

MP2100B BERTWave Operation Manual

조작 메뉴얼 pdf 6.8 MB Version: Fourth Edition 2017/02/17

Signal Integrity Solutions

Anritsu BERTs offer a wide variety of tools to measure the quality of high speed digital signals. Measurements, such as BER, skew and crosstalk can be determined between up to 8 channels at 32 Gb/s. Various types of jitter can be injected to evaluate jitter tolerance. Clock recovery can be used when different Tx and Rx clocks are employed. During EYE mask test and "bathtub" curve derivation emphasis and equalization can be applied to improve EYE openings.

리플렛 pdf 1.4 MB Version: A 2016/09/27

BERTWave™ MP2100B

The all-in-one MP2100B BERTWave supporting simultaneous BER and eye-pattern measurements. BERTWave support 4ch simultaneous BER measurement and Scope sampling speed support 150 ksample/s. BERTWave is ideal for both R&D and manufacturing tests because it increases efficiency and reduces measurement costs.

팜플렛 pdf 3.0 MB 2016/04/27

Jitter Analysis Software MX210001A

Simultaneous Jitter, EYE Pattern and EYE Mask Measurements

리플렛 pdf 779.4 KB 2016/04/04

Active Optical Cable (AOC) Measurement

To cope with rapid rises in data volumes, data centers are introducing active optical cable (AOC) interconnects with transmission speeds faster than 10 Gbit/s between servers. These interconnects require Eye pattern and BER measurements to assure quality while overcoming problems of longdistance transmissions, high speeds and power consumption.

리플렛 pdf 895.6 KB 2016/04/04

7.5 GHz Passive Probe Set J1512A

Ideal probe for GHz-band sampling oscilloscope, Choice of 10:1 or 20:1 attenuation ratio, Low capacity input ideal for monitoring high-speed signal waveforms, Short input ground lead ideal for high-frequency circuit evaluation.

리플렛 pdf 549.8 KB 2016/04/04

Transmission Analysis Software MX210002A

S21 Measurement, Linear Equalizer/Filter/Emphasis Waveform Simulation

리플렛 pdf 1.3 MB 2016/04/04

Total Solution for Optical Module Evaluation

Total Solution for Optical Module Evaluation / reduce Inspection Times and Improves Productivity MP2100B BERTWave MS9740A Optical Spectrum Analyzer.

리플렛 pdf 636.6 KB 2016/04/04

Ideal for LTE CPRI v6.1 Optical Module Evaluation

Simultaneous BER measurements, Eye/Pulse analysis and Jitter analysis using BERTWave increase efficiency and cut measurement time by eliminating time consuming setup. Fully supported LTE CPRI v6.1 bit rates make the BERTWave ideal for LTE CPRI optical transceiver mobile evaluation.

리플렛 pdf 446.7 KB 2016/04/04

Evaluation Transmission Characteristics of over Gbps Connectors/Cables

The MP2100B BERTWave series supports signal source (PPG), sampling oscilloscope, and BER measurement functions. Installing the MX210002A Transmission Analysis Software in the all-in-one MP2100B makes waveform, Eye Margin, BER and S21 measurements simple and fast.

리플렛 pdf 656.8 KB 2016/04/04

SCPI Sample Program

This Quick Reference Guide explains the setup and connections when running a SCPI sample program written in C# using NI-VISA. The sample program includes in MP2100B installer.

퀵 reference guide pdf 630.2 KB 2016/03/24

Jitter Analysis Software MX210001A / Transmission Analysis Software MX210002A

All-in-One Simultaneous Waveform Simulation, Jitter Analysis, Eye Pattern Measurement and Eye Mask Test

팜플렛 pdf 1.6 MB 2016/01/05

By Document Type

MX210000A BERTWave Software for MP2100B

MX210000A for MP2100B

MD5 : 4e719215d8ccc3ab0dc4cc48efae0ff2

driver/소프트웨어의 다운로드 exe 46.7 MB Version: 4.01.21 2018/11/01

MX210000A BERTWave Software Release Note

Changed history and update procedure for BERTWave software

driver/소프트웨어의 다운로드 pdf 869.9 KB Version: 35th Edition 2018/11/01

제품 카테고리별

기록을 찾을 수 없음
지역 이벤트, 문의 정보 및 특별 제안을 보려면 아래 국가를 확인하십시오.