Skip to main content

Download Center

Search by product Model Number

By Document Type

MG3690A RF/Microwave Signal Generators Technical Data Sheet

Technical Datasheet for the MG3690A RF/Microwave Signal Generators. 0.1 Hz to 65 GHz/110 GHz

Datasheet pdf 532.2 KB Version: E 4/7/2011

Synthesized Signal Generator MG369xA Operation Manual

This manual provides general information, installation, and operating information for the Anritsu series MG369XA synthesized signal generator. Throughout this manual, the terms MG369XA, signal generator, and synthesizer will be used interchangeably to refer to the instrument.

Operations Manual pdf 4.6 MB Version: H 4/24/2005

Synthesized Signal Generators MG369xA Maintenance Manual

This manual provides service information for the MG369xA Signal Generators. The service information includes replaceable parts information, troubleshooting, performance verification tests, calibration procedures, functional circuit descriptions and block diagrams, and assembly/subassembly removal and replacement. P/N: 10370-10355

Maintenance Manual pdf 4.1 MB Version: D 2/24/2005

Synthesized Signal Generators MG369xA GPIB Programming Manual

This Programming Manual is for the MG3690A series.

Programming Manual pdf 931.7 KB Version: D 1/1/2004

Synthesized Signal Generator MG369xA SCPI Programming Manual

This manual provides information for remote operation of the Series MG369XA Synthesized High Performance Signal Generators using commands sent from an external controller via the IEEE-488 General Purpose Interface Bus (GPIB).

Programming Manual pdf 674.2 KB Version: B 1/17/2003

By Document Type

MG3690 Series Drivers

This file contains drivers that can be used with Anritsu synthesizer signal generators. There are drivers applicable to the MG3690C Series (including MG3691C, MG3692C, MG3693C, MG3694C, MG3695C, MG3697C), the MG3690B Series (including MG3691B, MG3692B, MG3693B, MG3694B, MG3695B, MG3696B), and older models included in the MG3690A series, 68000B series, 68100B series, 68200B series, and 68300B series.

Drivers Software Downloads zip 23.6 MB Version: A 1/30/2013

MG3670 Base Unit Driver

LabVIEW Driver version 1.0

Drivers Software Downloads EXE 532.6 KB 1/1/1998

By Product Category

What temperature does the MG3690B/C series signal generator have to reach before it shuts down?

The maximum operating temperature is +50 degrees celsius. The units internal power supply has a temperature sensor which will open at some temperature above +50 degrees celsius and the unit will then perform a power down. If the temperature of the power supply sensor is lowered back to an operating temperature then it closes and the unit will turn back on.

Can the MG3692C send signals into loop antennas with signal input levels up to or close to +20 dBm?

The instrument will not be damaged by driving the antenna over the frequency range specified in the data sheet for the antenna. However, since the antenna does not present a 50 ohm load to the generator, the actual power delivered to the antenna will be different than that displayed on the front panel of the MG3692C. The user will need to somehow monitor the power to the antenna under the actual use conditions in order to accurately determine the power being delivered. The best way to do this would be to set the MG3692C power level to provide a given field strength from the antenna without regard to the numeric setting of the front panel level indicator on the MG3692C