Skip to main content

Spectrum Analyzer

MS2683A
This product has been discontinued Replacement Model(s) : MS2830A
Overview
  • Frequency Range
    • 9 kHz to 7.8 GHz
  • Resolution Bandwidth
    • Up to 20 MHz
    • Optional narrow resolution bandwidth from 1 Hz
  • High-performance specifications

The MS2683A Spectrum Analyzer delivers optimum performance over the wide dynamic range (156 dB, typical value), wide resolution bandwidth (20 MHz), and the high-speed sweep (refresh rate of 20 times/s), required for evaluating next-generation radio communication systems and devices.

With optional analysis software, the MS2683A becomes more than a Spectrum Analyzer as it performs analysis on digital communication standards.


Applications
  • Communication System R&D
  • High-Speed Measurements of Radio and Device Manufacturing Lines

Options

Communication System

Applicable Software

W-CDMAW-CDMA Measurement Software
GSMGSM Measurement Software
cdmaOne, CDMA2000 1XCDMA Measurement Software
CDMA2000 1xEV-DOCDMA2000 1xEV-DO Measurement Software
PDC/PHS/NADC (IS-136), STD-39/T79, STD-T61π/4DQPSK Measurement Software
IEEE802.11a/11b/11g, HiSWANa, HiperLAN2Wireless LAN Measurement Software
TD-SCDMATD-SCDMA Measurement Software


Precision frequency referenceAging rate:  ±5 × 10–10/day
Narrow resolution bandwidth (FFT)1 Hz to 1 KHz
Extension of Preselector lower limitExtends the lower frequency from 3.15 GHz to 1.6 GHz
Digital resolution bandwidth (RMS detection)Adds RMS detection and expands resolution bandwidth to 10 Hz to 1 MHz
Pre-amplifierInstalls a pre-amplifier with 20 dB gain typical value and frequency range from 100 kHz to 3 GHz
Ethernet interfaceAllows external control via 10BASE-T
I/Q balanced inputMounts 4 connectors for I/Q sync input and operating input (BNC type) to the front panel

Measurement software corresponding to I/Q input is required for actual measurement
I/Q unbalanced inputMounts 2 connectors for I/Q synch inputs and operating inputs (BNC type) to the front panel

Measurement software corresponding to I/Q input is required for actual measurement
4 GHz LO outputOutputs internal 2nd local signal through rear connector
Auto power recoveryDisables the power switch on the front panel

Power is automatically reset after the line is restored
Rack mount (IEC) without handlesMounts an IEC standard rack mount

Eliminates the standard tilt handle
Rack mount (JIS) without handlesMounts a JIS standard rack mount

Eliminates the standard tilt handle

Library